![]() To implement this in LTspice, perform the following steps: Here is an example waveform response of an RC circuit, for which the capacitance is stepped through three values. step command causes an analysis to be repeatedly performed while stepping through a model parameter, global parameter or independent source. step command to sweep across a range of values in a single simulation run. ![]() There are two ways to examine a circuit in LTspice by changing the value for a particular parameter: you can either manually enter each value and then simulate the circuit to view the response, or use the. ![]() STEP Command to Perform Repeated Analysis ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |